Wow almost one month never touch my rollerblade nor try out my new wheels. Finally today decided to go skate again haha. I have not season my new wheels yet, i was planning to season them using T-brake and powerslide. Lazy to use sandpapaer to sand off the wax. Thanks to Shanli for the advice. :)
This is before my seasoning. I place all the 4 new wheels on one side, my sliding foot. Make sense since only my right foot will do the slide on the floor. See my wheels still very white and clean.
I did loads of T-brakes initially, followed by powerslides. This method was really good, pretty soon my wheels became seasoned. Flip them over and season the other side too. Finally when both sides were done, i put them nicely. This is my new setting. One thing i realised after buying my wheels was, that the outermost front and back wheels were smaller than 76mm. So then i know that outermost front and back wheels tend to wear off faster than the middle two wheels. And thus, i put the new white wheels in the middle.
 |
